This article includes a list of references, but its sources remain unclear because it has insufficient inline citations. (April 2010) (Learn how and when to remove this template message)
Composite color video signal
Composite color video signal (CCVS) consists of three terms:
- Monochrome (luminance) signal
- Auxiliary signals (sync pulse and blanking signals )
- Color signal, which is actually a subcarrier modulated by chroma information
The first two terms are usually called composite video signal (CVS)
The modulation technique of the color subcarrier is quadrature amplitude modulation (QAM) both in PAL and NTSC systems. The amplitude of the color signal represents the saturation of the color and the phase lag of the color signal with respect to a certain reference which is called colorburst represents the hue; i.e., each phase lag is assigned for a different color hue. So, in order to reproduce the original color in the receiver, the phase difference between the colorburst and the color signal must be kept constant throughout the broadcasting.
The colorburst is a 10 period signal of color carrier (3.58 MHz in System M and 4.43 MHz in System B and System G). It is superimposed on the back porch of the CVS. The peak to peak amplitude is about 300 mV. That means that, when the color signal has a low luminance, its DC component is comparable to that of the colorburst. All dark colors have more or less the same DC component as the colorburst. But light colors have a higher luminance and hence a higher DC component.
Differential phase distortion
During broadcasting, the inherent non linearity in electronic devices may cause a level dependent phase shift. Differential phase distortion (DP or dP) is the shift of color signal phase with respect to the colorburst phase. When DC levels of the light colors and the colorburst are different, the hue of the light colors may change . Especially a slight change in skin color may be irritating to the viewers. (too yellow or too red skin color depending on whether shift is positive or negative)
To solve the problem of differential phase distortion in PAL system, the polarity of both the colorburst and the color signal are reversed in each consecutive frame. So in one frame the phase of the colorburst leads and in the second frame the phase of the color signal leads. However, if there is DP distortion in the system, the shift caused by DP has always the same polarity, thus the overall shift is more than the original in one frame and less than the original in the second frame by the same amount. The average of two frames yields the original phase difference and thus the color.
The mathematics involved is as follows:
Let be the phase difference of the color signal with respect to colorburst and be the extra shift introduced by DP.
The original signal is
If there is a DP distortion, the received signal for the first frame is
In the second frame (after multiplying by -1)
The average is
So while the effect of diminishes on the color hue, the amplitude of the color signal is reduced by which means that color saturation is reduced.
- Television Measurements: NTSC Systems Archived 2009-06-12 at the Wayback Machine. Techtronix
- Gordon J.King:Beginner’s Guide to color television, Newness technical, London, 1978; ISBN 0-408-00101-1, p 65-70
- V.F.Samoylov-B.P.Khromoy: Television (trans:Boris Kuznetsov) Mir Publishers, Moscow, 1977, p.375